Unpack Circuit Breaker - ABB AKR30S-800A Installation And Maintenance Manual

Unpack Circuit Breaker
Danger .
9 e Turn off all power to switchgear. Tagout
and lockout main source, up-stream or main
ieosionhacarie breaker.
neces e Failure to comply with these instructions
will result in death or serious injury from severe
burns caused by arc flashing that has
exceedingly high temperatures.
A DANGER e Always wear personal protection equipment
according to OSHA standards and appropriate
to the severity of potential burns.
e Ensure only qualified personnel install, operate, service, and maintain all electrical
equipment.
Caution
| A CAUTION | e Do not walk or remain under any heavy
assembly while hoisted above head as the
chains securing the assembly may give way.
Falling Object
e Ensure lifting equipment has capability for device being lifted.
@ Wear hard hat, gloves, and safety shoes.
e Failure to comply with these instructions could result in serious injury.
Notice PRODUCT DAMAGE
e Ensure circuit breaker and its accessories are always
NOTICE used within their designated ratings.
e Donot allow the circuit breaker to hit a hard surface
while handling.
e Donotdrag or slide the circuit breaker across a hard
or rough surface
e A factory-installed rejection feature prevents mismatching circuit breakers and
cassettes/ substructure, preventing the insertion of a circuit breaker with a lower
rating into a higher rated cassette/substructure, or the insertion of a higher rated
circuit breaker into a lower rated cassette/substructure.
By following the procedures below, you should be able to install the breaker with minimum
effort and time.
22| © 2020 Emax 2 Retrofill Circuit Breakers 800-5000A 2TSA451009P0000 Rev-B