Positioning The Turf Compensating Spring - Toro Reelmaster 7000-D Operator's Manual

Positioning the Turf Compensating Spring

Cutting Unit 2
Cutting unit 1
Cutting unit 2
1. If the hairpin
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
2. Remove the 2 flange locknuts (3/8 inch)
and 2 carriage bolts (3/8 x 1-1/4 inches)
that secure the turf-compensator bracket
the cutting-unit frame.
3466-706A
Cutting unit 3
Cutting unit 4
is installed in the rear hole of
Page 3–6
G410999
Cutting unit 5
Reel motor
G410292
to
G410293
Weight
Setup: Installing the Cutting Units