Shutting Off The Engine; Locking The Cutting-Unit Pivot - Toro Reelmaster 7000-D Operator's Manual

Starting the Engine (continued)
Do not run the starter motor more than 15 seconds at a time, or premature starter
failure may result. If the engine fails to start after 15 seconds, turn the key to the O
position, check the controls and procedures, wait 15 additional seconds, and repeat
the starting procedure.
When the temperature is less than -7°C (20°F), the starter motor can be run for 30
seconds on then 60 seconds off for 2 attempts.
5. When the engine starts, release the key.
6. Adjust the engine speed.

Shutting Off the Engine

1. Park the machine on a level surface.
2. Press the PTO switch to the D
3. Move the engine-throttle control to the S
4. Engage the parking brake.
5. Lower the cutting units.
Lowering the cutting units relieves the hydraulic load from the system, prevents wear
on system parts, and prevents accidental lowering of the cutting units.
6. Rotate the key to O
7. Wait for all moving parts to stop.

Locking the Cutting-Unit Pivot

Cutting Grass on a Hill Side
Lock the cutting-unit pivots to prevent the cutting units from rotating downhill when cutting
across the face of a hill.
3466-706A
IMPORTANT
position.
ISENGAGE
IMPORTANT
and remove the key.
FF
Page 5–12
position.
LOW
FF
Operation: During Operation