Entering Cutting Unit Settings; Preparing The Machine - Toro Reelmaster 7000-D Operator's Manual
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Entering Cutting Unit Settings
Use the PIN code to enter the following cutting-unit information into the InfoCenter:
• Blade count
• Mow speed
• Height of cut
Preparing the Machine
3
1. Park the machine on a level surface, lower the cutting units, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait for all moving parts to stop.
3. Check the tire air pressure before use.
Note:
operating the machine.
4. Check the rear-axle lubricant level.
5. Check the hydraulic-fluid level.
6. Grease the machine.
Failure to properly grease the machine will result in premature failure of critical parts.
7. Open the hood and check the coolant level.
8. Check the level of the engine-oil level, and close and latch the hood.
Note:
and after the engine is first started.
3466-706A
The tires are overinflated for shipping. Adjust the tire air pressure before
The engine ships with oil in the crankcase; however, check the oil level before
IMPORTANT
Page 3–12
Setup: Installing the Cutting Units
Advertisement
Table of Contents
