Tie-Down Point Locations; Hauling The Machine - Toro Reelmaster 7000-D Operator's Manual
4-wheel drive traction unit
Hide thumbs
Also See for Reelmaster 7000-D:
- Service manual (468 pages) ,
- Operator's manual (144 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Pushing or Towing the Machine Forward (continued)
Do not push or tow the machine faster than 3 to 4.8 km/h (2 to 3 mph) or for more than
0.4 km (1/4 mile), because damage to the hydraulic system may occur. The bypass
valve must be open whenever you push or tow the machine.
4. When the machine is ready for operation, close the tow-bypass valve by rotating it back
90° (1/4 turn) before starting the engine.
Note:
Tie-Down Point Locations
Front tie-down points
Hauling the Machine
Follow the tips below when hauling the machine.
• Use full-width ramps for loading the machine onto a trailer or truck.
• Tie the machine down securely.
Operation: Tie-Down Point Locations
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb) torque to close the valve.
IMPORTANT
G424086
Rear tie-down point
Page 5–23
3466-706 A
Advertisement
Table of Contents
