Configuring Ifr 3901/Ifr 3902/Ifr 3920 Manual Screen Test - Motorola MXP600 Manual

15 Press Max Transmitter Level. Enter 30 dBm and press Max Transmitter Level.
16 Press Access Parameter. Enter -53 dBm and press Access Parameter.
17 Press Test Mode→Enable.
18 Press Base Service.
NOTE: You are entering base services setup. The displayed value are factory defaults
and should not be changed.
Power On Registration: Required
Power Off De-registration: Required
Priority Cell: Yes
Minimum Mode Service: May Be Used
Migration: Supported
System Wide Services: Normal Mode
19 Press More.
TETRA Voice Service: Supported
Circuit Mode Data Service: Supported
(Reserved): Available
SNDCP Service: Available
Air Interface Encryption: Not Available
Advanced Link: Not Supported
20 Press Return. Select Neighbor Cell.
21 Verify that the following NEIGHBOUR CELL INFO values are displayed:
NOTE: The displayed values are factory defaults and should not be changed.
BROADCAST: Not Required
BROADCAST INTERVAL: 5 s
NEIGHBOUR CELL CHANNEL: 3500
NEIGHBOUR CELL LOCATION AREA: 00017
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD ABOVE FAST: 10 dB
22 Press More.
FAST RE-SELECT THRESHOLD: 10 dB
SLOW RE-SELECT HYSTERESIS: 10 dB
FAST RE-SELECT HYSTERESIS: 10 dB
23 Press Return.
24 Press Trunk Type→message Trunked (Transmission).
25 Press More.
NOTE: The displayed values are factory defaults and should not be changed. It is not
required to configure Call Types, Call Arial, and Messages.
26 Press More.
4.5

Configuring IFR 3901/IFR 3902/IFR 3920 Manual Screen Test

Procedure:
1 Press TEST→TAB.
2 Enter 3600 for Control Channel.
3 Enter 3700 for Traffic Channel.
MN006362A01-AL
Chapter 4 : Test Setup and Testing
39