Configuring Ifr 2968 Manual Screen Test; Rf Tests; Testing Receiver Using Ifr 3901/Ifr 3902/Ifr 3920 - Motorola MXP600 Manual

MN006362A01-AL
Chapter 4 : Test Setup and Testing
4 Enter 3 for Slot.
5 Enter -75 for RF Gen Level.
6 Select Expected→30.0 dBm/1 W for Mobile Power.
7 To select Transmitter Measurements, press TAB.
8 Press Normal for Burst.
The test equipment configuration setup is completed.
NOTE: The System Setup Configuration Data is saved even after the power is turned off.
However, the Manual Test Setup is not saved.
4.6

Configuring IFR 2968 Manual Screen Test

Procedure:
1 Press Manual to enter the Manual Test screen.
2 Press Control Channel. Enter 3605 and press Control Channel.
(IFR 3605 = Receiver 390.125000 MHz)
3 Press Traffic Channel. Enter 3605 and press Traffic Channel.
The marker goes to Timeslot.
4 Enter 3 and press Traffic Channel.
NOTE: The Traffic Channel number changes automatically after entering the Control
Channel number.
5 Press RF Gen Level. Enter -75 and press dBm→RF Gen Level.
6 Press Mobile Power. Enter 30 dBm/1 W.
7 Press Burst Type→Normal.
The test equipment configuration setup is completed.
NOTE: The System Setup Configuration Data is saved even after the power is turned off.
However, the Manual Test Setup is not saved.
4.7

RF Tests

This section lists the applicable RF Tests and its procedures for the radio.
4.7.1

Testing Receiver Using IFR 3901/IFR 3902/IFR 3920

Prerequisites: This test requires programming the radio. Refer to TETRA Customer Programming
Software (CPS) User Guide.
Procedure:
1 Turn ON the radio.
2 Do one of the following to enter the radio test page:
• Use CPS.
• Press Left→Right→Left→Menu.
40