Applicable Standards; Ce Marking; Compliance With The European Low Voltage Directive; Compliance With The European Emc Directive - ABB ACS880-77CC Hardware Manual

Applicable standards

• EN 60204-1:2006 +
A1:2009 + AC:2010
• EN 60529:1991
• IEC 61439:2020
• IEC 61400-1:2019
• IEC 61800-3:2017,
EN 61800-3:2004 +
AMD1:2012
• EN 61800-5-1:2007,
IEC 61800-5-1:2007 +
AMD1:2016
• BS7671
• IEC 62477-
1:2012/AMD1:2016
• UL 61800-5-1
• CSA C22.2 NO.
107.1:16

CE marking

A CE mark is attached to the converter to verify that the converter follows the provisions of
the European Low Voltage Directive 2014/35/EU (previously 2006/95/EC) and EMC Directive
2014/30/EU (previously 2004/108/EC).

Compliance with the European Low Voltage Directive

￭
The compliance with the European Low Voltage Directive has been verified according to
standard EN 61800-5-1.

Compliance with the European EMC Directive

￭
See section Compliance with EN 61800-3:2004/A1:2012 (page

UKCA mark

UKCA (UK Conformity Assessed) mark
Product complies with the applicable United Kingdom's legislation (Statutory Instruments). Marking
is required for products being placed on the market in Great Britain (England, Wales and Scotland).

Compliance with the European Machinery Directive

Note: In standard texts, the term 'drive' stands for 'converter' in case of wind turbine
applications.
The converter complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standards EN 61800-5-1.
Safety of machinery. Electrical equipment of machines. Part 1: General require-
ments. Provisions for compliance: The final assembler of the machine is responsible
for installing
- an emergency-stop device.
Degrees of protection provided by enclosures (IP code)
Low-voltage switchgear and controlgear assemblies
Wind turbines. Part 1: Design requirements
Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods
Adjustable speed electrical power drive systems. Part 5-1: Safety requirements –
electrical, thermal and energy.
Requirements for electrical installations
Safety requirements for power electronic converter systems and equipment - Part
1: General
Adjustable Speed Electrical Power Drive Systems - Part 5-1: Safety Requirements
- Electrical, Thermal and Energy. See section
Power conversion equipment
Technical data 95
ETL marking (page 97).
96).