Table of Contents
Advertisement
The
warning light is flashing orange.
High-speed cooling is in progress. If the projector gets too hot again, projection stops
automatically. Make sure there is plenty of space around and under the projector for
ventilation. Clean or replace the air filter if necessary (see page 51).
The
warning light is red.
The projector is too hot, which turns off the lamp automatically. Let it cool for five minutes,
then turn it back on. Make sure there is plenty of space around and under the projector for
ventilation. Also, clean or replace the filter if necessary (see page 51).
The
warning light is flashing red at one-second intervals.
■
The lamp cover may be loose or off. Make sure it's securely fastened (see page 52).
■
There is an internal problem. Turn off the projector and, when the P power light stops
flashing, unplug it. Contact your dealer.
The
warning light is flashing red at half-second intervals.
The lamp needs to be replaced (see page 52).
Checking the Projector Status
You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the
2. Use the menu navigation buttons to open the
appears:
■
Lamp Hours
■
Source
■
Input Signal
■
Resolution
Note: The information displayed depends on the currently selected image source.
The Lamp Hours shows 0H until you've used the lamp for at least 10 hours.
56
button on the projector or remote control.
Menu
menu. The following information
Info
■
Video Signal
■
Refresh Rate
■
Sync Info
Advertisement
Table of Contents
