Using Dos-Based Functions; Changing The Volume - NEC VERSA MEDIADOCK 2000 User Manual

Using DOS-Based Functions

Two sound control utilities are stored on your hard disk
drive when you run the MediaDock 2000 Setup utility.
When using applications that run from MS-DOS, you may
need to change these sound settings.
The following two utilities let you adjust the speaker vol-
ume and change the DMA and IRQ addresses.
T
ESSVOL.EXE — allows you to increase or decrease
the volume of the sound coming from your MediaDock
2000.
T
ESSCFG.EXE — allows you to change DMA and IRQ
settings if your application requires that you do so.
Only change these settings if you try to run a DOS-based
application and you get no sound or poor sound from the
MediaDock 2000.

Changing the Volume

Change speaker volume settings as follows.
From the DOS prompt, type the following and press
1.
Enter
2. Display the current sound settings by typing the follow-
ing and pressing
The screen displays the current volume settings.
3-8 Setting Up and Using the Software
to change to the MD2000 directory.
cd MD2000
.
Enter
essvol