Table of Contents
Advertisement
Using the PC Card Slots
When using PC cards in your NEC Versa system, please note the following:
To ensure optimal functionality when using SRAM cards in your NEC Versa, insert
!
the SRAM card in the top PC card slot.
Before using two PC cards at the same time in your NEC Versa system, you may
!
have to disable another system device to release an IRQ (system interrupt) for PC
card use.
To disable a device (such as the serial port) in Windows 98, go to Start, Settings,
Control Panel, System, and access the Device Manager. To disable a device in
Windows 95/NT, reboot your system, enter the BIOS setup and access the
Peripheral Setup menu.
Inserting a PC Card
To insert a PC card, follow these steps.
1.
Align the card so that the 68-pin connector points towards the slot and the arrow
shows on the top face of the card.
2.
Slide the card into either slot. (Install Type III cards in the bottom slot, only.) A
low tone followed by a high tone lets you know that the card is fully inserted and
recognized. If you turn off the sound through the function keys or volume control,
no sound is emitted. If you insert the card before powering on the system, the tones
are emitted during bootup.
6-4 Communicating with Your NEC Versa
Advertisement
Table of Contents
