Table of Contents
Advertisement
LCD Suspend — Allows you to suspend/resume when the LCD panel is closed.
!
Suspend Option — Specifies either Suspend or Save to File (STF) when the LCD
!
Suspend parameter is enabled. For more details about using this parameter, see the
section, "Managing System Power," later in this chapter.
Automatic STF — Enables the system, after 30 minutes in Suspend mode, to save
!
the current working environment to a special file on the hard disk and to power
down the system.
Pressing the
(Windows 95/NT, only). For more details about using this parameter, see the
section, "Managing System Power," later in this chapter. For details about creating
the save-to-file area, see the section, "HDPREPEZ Utility," in Chapter 4.
Panel Brightness — Selects the LCD screen brightness.
!
Suspend Warning Tone — Specifies whether the system warning tone sounds when
!
Suspend mode starts. It is best to keep this option enabled.
Remote Power On — Allows the serial port modem or LAN board to wake the
!
system on a ring signal.
Wake Up from Suspend Alarm/Resume Alarm Time — Allows the alarm to resume
!
the system from suspend. Designates the time parameter in five minutes increments.
(Not applicable in Windows 98 with ACPI.)
Intel SpeedStep — Optimizes CPU performance when the system is powered under
!
AC or by battery.
3-14 Using the BIOS Setup Utility
Option
Audio Device
Timeout
Standby Timeout
Auto Suspend
Timeout
key combination also puts the system into Save to File mode
Fn-Power
Custom Timeout Options
Definition
Sets the time delay before your audio device powers
off.
Selects the system standby timeout period.
Defines how much time elapses from the time the
system enters Standby mode to the time the system
automatically enters Suspend mode.
Advertisement
Table of Contents
