Table of Contents
Advertisement
Establishing Hard Disk Drive Passwords
To establish password protection for your system's hard disk drive you must establish a
master password, establish a user password, and enable the established passwords for
the internal HDD and for an HDD installed in the NEC VersaBay III. Follow these
steps to establish HDD passwords and to enable HDD password protection.
1.
Enter the BIOS setup, highlight and select the System Security Setup.
Highlight Assign HDD Password and press
2.
The system prompts you to enter a master password.
3.
Enter a master HDD password and press
The system prompts you to enter the password again to verify.
Enter the master password and press
4.
The system confirms the creation of the master password and prompts you to enter
a user password.
5.
Enter a user password and press
The system prompts you to enter the password again to verify.
Enter the user password and press
6.
Highlight and select Internal HDD Password and use the
7.
enable the selection. (Follow this step to enable password protection for the
internal HDD.)
8.
Highlight and select VersaBay HDD Password and use the
enable the selection. (Follow this step to enable password protection for an HDD
installed in the NEC VersaBay III.)
Changing Hard Disk Drive Passwords
To change hard disk drive passwords, enter the System Security Setup, highlight
Internal HDD Password and enter the current password that you wish to change. If you
enter the current master password, you are prompted to enter a new master password. If
you enter the current user password, you are prompted to enter the new user password.
If you do not wish to establish a new master or user password, press
entering a new password. Save your changes and exit BIOS setup.
3-10 Using the BIOS Setup Utility
.
Enter
Enter
.
.
Enter
Enter
.
.
Enter
keys to
PgUp/PgDn
PgUp/PgDn
keys to
instead of
Esc
Advertisement
Table of Contents
