Table of Contents
Advertisement
Docking Station Video — Selects whether or not a video card installed in the
!
Docking Station is enabled at system boot.
BootUp NumLock — Specifies whether NumLock is On or Off at system startup.
!
Boot Devices — Specifies the sequence of boot devices and whether or not the
!
system attempts to boot from a device other than those specified.
Other Boot Devices — Allows you to specify IDE devices as bootable devices.
!
Peripheral Setup
The Peripheral Setup menu displays the connection locations between the system and
the Input/Output (I/O) ports and lets you specify different port assignments as needed.
Parameter
USB Controller
Internal Hard Drive
Serial Port
Parallel Port
Parallel Mode
IR Serial Port
Note
using the Windows device manager. The device will not be listed in the Windows device
list. To control the device using the Windows device manager, select any setting other
than Disabled in Peripheral Setup.
Peripheral Setup allows you to define the following functions.
USB Controller — Enables or disables the USB controller.
!
Internal Hard Drive — Selects which IDE controller is enabled.
!
Serial Port — Disables the port or changes its IRQ and COM port assignment.
!
3-16 Using the BIOS Setup Utility
If you disable a device in Peripheral Setup, you cannot enable or assign it
Peripheral Setup
Default Setting
Disabled
Both
Auto
Auto
Bi-Dir
Disabled
Alternate Setting(s)
Enabled
Enabled/Disabled
Primary/Secondary
Disabled
COM1,IRQ4/COM2,IRQ3
COM3,IRQ4/COM4,IRQ3
Disabled/LPT1/LPT2
Uni-Directional/ECP/EPP
Auto
COM2,IRQ3/COM3,IRQ4/
COM4,IRQ3
Advertisement
Table of Contents
