Table of Contents
Advertisement
Problem
An optional component
does not work.
The Power button does
not resume the system
from:
Suspend (Windows
95/NT) or Standby
(Windows 98) mode.
The system does not
automatically enter
Suspend (Windows
95/NT) or Standby
(Windows 98).
Upon resuming from a
manual STF the system
displays the message,
"Following system
component(s) changed
since last Suspend
(Windows 95/NT) or
Standby (Windows 98) –
System Memory. Do you
want to (B)oot or (P)ower
down?"
Start-Up Problems
The system displays an invalid configuration error message at power on when there are
the following conditions:
the current configuration information does not match configuration information
!
stored in Auto Setup, such as when an internal option is added.
the system loses configuration information.
!
If either condition is true, the system displays an "invalid configuration information"
message.
To continue start-up procedures, press
utility to set current system parameters.
Troubleshooting
Resolution
Make sure the component is securely installed or
connected. Verify that the system parameter for the I/O
port configuration is set correctly in Setup.
If system does not resume, it may have automatically
entered Suspend (Windows 95/NT) or Standby
(Windows 98) on a low battery. Attach the AC adapter
and try again.
A disk drive might be busy. Wait until the disk drive
stops and try again.
Check that Auto Play is disabled. See "Changing the
Auto Play Setting" in Chapter 5 for details.
Power down the system and reseat the memory.
If new memory was installed prior to manual STF,
remove new memory before resuming from Suspend
(Windows 95/NT) or Standby (Windows 98) mode.
F2
(or
F1
when prompted) and run the Setup
Solving System Problems 10-3
Advertisement
Table of Contents
