HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions page 121

NOTE The MAC address is unique to each remote management card and is used
for identification. This address cannot be configured.
To successfully use BOOTP from the library, the system administrator
must first configure the BOOTP server using the MAC address.
5. Enter the IP Address.
6. Enter the subnet mask using the same procedure.
7. Enter the gateway address.
8. Press
9. Enter the designated IP address into the web browser to launch the
NOTE To use a device name, the system administrator must add the device
name you select to the domain name server (DNS).
NOTE Instructions and help screens describing remote management are
available from the Web-Based Library Administrator web pages by
selecting the
Appendix A
Use the key to change the number.
[+]
Use the key to move to the next number.
[->]
Use the key to move to the next address.
[Down]
when complete to save the changes, or press
[OK]
the menu and not save the changes.
A message will display to confirm the changes you have entered, or
alert you if the changes have not been saved.
Web-Based Library Administrator pages.
Example 1 - All modes (manual, DHCP, or BOOTP):
IP address = 15.28.33.12
http://15.28.33.12
Example 2 - Manual and BOOTP only:
Device name = library1
http://library1
button in the top right-hand corner of any page.
[?]
Configuring the Library
Configuring the Remote Management Card
[Quit]
to exit
A-3