To add a card to the library:
1. Power off the library.
2. Select the appropriate location for the card, and remove the vacant
3. Align the top and bottom edges of the card you are adding with the
4. Gently push the card into the library until the card is flush with the
5. Tighten the thumbscrews (finger tight).
6. Connect external cable(s).
7. Add the upgrade serial number label to the pull-out tab on the back of
8. Power on the library.
If the new card has a different version of firmware than the library, the
NOTE
library could go into a partial availability state due to a firmware
mismatch. In this state, the front panel will display
the LED bar beneath the front panel display will be solid amber. If this
occurs, then download the most recent library firmware (See "Upgrading
Firmware" on page 3-2.)
9. If installing Fibre Channel or remote management cards, configure
Chapter 1
slot cover. See Figure 1-4 on page 1-12.
card slot.
library.
the library. Apply this label to the tape library to ensure proper
identification of any upgrades you do.
the new card from the library front panel. See Appendix A,
Configuring the Library for more information.
Adding Fibre Channel or Remote Management Cards
Upgrading the Library
, and
Partly Available
1-13