NOTE
NOTE
Configuring the Library
Configuring the Library for Fibre Channel
Configuring the Library for Fibre Channel
It is not necessary to connect the library to its Fibre Channel topology
(arbitrated loop or fabric) before configuration.
Configuration
When Fibre Channel controller cards are installed in the library, device
SCSI IDs cannot be changed from their factory default.
Though you do not need to set SCSI IDs for Fibre Channel, you will need
to configure Fibre Channel addressing.
->
Main Menu
Administration
Change Configuration
1. Enter the
Fibre Channel
2. Select the level where the Fibre Channel controller card you want to
configure is located.
Use the
key to select a lower level in the library.
[-]
Use the
key to select a higher level in the library.
[+]
Select
if the level is correct.
[OK]
A-4
->
->
Fibre Channel
menu.
Appendix A