Removing The Transport Assembly - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

CAUTION
Figure 2-21
NOTE
Removing and Replacing Major Library Components
Removing and Replacing the Transport Assembly (for Model 12/140 only)

Removing the Transport Assembly

1. Using the finger-holes in the top of the transport assembly, lift the
assembly up and out of the library (Figure 2-21).
Use care to protect the flat, umbilical cable attached to the bottom of the
transport assembly.
Removing the Transport Assembly
2. Place the transport assembly next to the library and disconnect the
umbilical cable by pulling the tabs outward (Figure 2-21).
3. If you are only replacing the transport assembly and not the vertical
lift motor, remove the motor to install on the replacement transport
assembly. See "Replacing the Vertical Lift Assembly" on page 2-48 for
more information.
You need to remove the guide blocks on the replacement transport
assembly to install the vertical lift assembly. See Figure 2-14 on page 2-
33.
2-44 Chapter 2