5. Connect the external cables and terminator to the drive.
• For SCSI configurations: Daisy-chain the library controller to
the first (left) drive. Connect each subsequent drive to the host
interface card so that it each drive is on its own bus. Terminate
the library controller and the right drive. (See Figure 1-2 on page
1-8 for an example.)
• For Fibre configurations: See Figure 1-3 on page 1-9 for an
example of how to cable a Fibre Channel library and page A-4 for
front panel configuration information.
6. Add the upgrade serial number label to the pull-out tab on the back of
the library. Apply this label to the tape library to ensure proper
identification of any upgrades.
Chapter 1
Upgrading the Library
Upgrading Drive Capacity
1-7