Captive Portal Statistics; Cli Examples - Dell PowerConnect M6348 Configuration Manual
Configuration guide
Hide thumbs
Also See for PowerConnect M6348:
- Cli reference manual (1152 pages) ,
- Getting started manual (208 pages) ,
- User configuration manual (1294 pages)
Table of Contents
Advertisement
The size of the table has a limit of 1024 entries. If the list becomes full, new table entries are rejected and
a trap is sent for every rejected client.
Captive Portal Statistics
Client session statistics are available for both guest and authenticated users.Client statistics are used to
enforce the idle timeout and other limits configured for the user and captive portal instance. Client
statistics may not be cleared by the administrator since this would affect the ability to monitor the
configured limits.
CLI Examples
Example 1: Enter Captive Portal configuration mode
To enter Captive Portal configuration mode, use the following command:
console(config)#captive-portal
console(config-CP)#
Example 2: Enable Captive Portal
To globally enable Captive Portal, use the following command (Captive Portal configuration mode):
console(config-CP)#enable
Example 3: Enable Captive Portal on Additional HTTP Port
To configure an additional HTTP port for Captive Portal to monitor, use the following command
(Captive Portal configuration mode):
console(config-CP)#http port 81
Example 4: Configure Captive Portal Authentication Timeout
To configure the Captive Portal authentication timeout (600 seconds), use the following command
(Captive Portal configuration mode):
console(config-CP)#authentication timeout 600
122
Device Security
Advertisement
Table of Contents
