Link Layer Discovery Protocol; Cli Examples - Dell PowerConnect M6348 Configuration Manual

discard
max
trap
console(config-if-1/g18)#port security
Example #2: Show Port Security
console#show ports security ?
addresses
ethernet
port-channel
<cr>
Example #3: Show Port Security on an Interface
console#show ports security ethernet 1/g18
Port Status
----- --------
1/g18 Locked

Link Layer Discovery Protocol

The Link Layer Discovery Protocol (LLDP) feature allows individual interfaces on the switch to advertise
major capabilities and physical descriptions. Network managers can view this information and identify
system topology and detect bad configurations on the LAN.
LLDP has separately configurable transmit and receive functions. Interfaces can transmit and receive
LLDP information.

CLI Examples

Example #1: Set Global LLDP Parameters
Use the following sequence to specify switch-wide notification interval and timers for all LLDP
interfaces.
console#configure
console(config)#lldp ?
notification-interval
timers
console(config)#lldp notification-interval ?
40
Switching Configuration
Discard frames with unlearned source addresses.
Configure the maximum addresses that can be learned
on the port.
Sends SNMP Traps, and specifies the minimum time
between consecutive traps.
Addresses.
Ethernet port.
Link Aggregation interface.
Press enter to execute the command.
Action
-----------------
Discard
Configure minimum interval to send remote data
change notifications.
Configure the LLDP global timer values.
Maximum Trap
------- -------
100 Disable
Frequency
---------
30