The PowerConnect M6220/M6348/M8024 switches support both versions of RIP . You may configure a
given port:
•
To receive packets in either or both formats
•
To transmit packets formatted for RIP-1 or RIP-2 or to send RIP-2 packets to the RIP-1 broadcast
address
•
To prevent any RIP packets from being received
•
To prevent any RIP packets from being transmitted
CLI Examples
The configuration commands used in the following example enable RIP on ports vlan 2 and vlan 3 as
shown in the network illustrated in Figure 4-6.
Figure 4-6. Port Routing Example Network Diagram
Example #1: Enable Routing for the Switch
The following sequence enables routing for the switch:
console#config
ip routing
exit
VLAN 3
192.130.3.1
192.130.3.1
Layer 3 Switch
acting as a router
VLAN 2
Port 1/0/2
192.150.2.2
192.150.2.2
Subnet 2
Port 1/0/3
VLAN 5
192.64.4.1
Port 1/0/5
192.64.4.1
Subnet 3
Subnet 5
Routing Configuration
85