Brother HL 5030 - B/W Laser Printer Service Manual page 49

CHAPTER 2 INSTALLATION AND BASIC OPERATION
(2) Open the back output tray.
(3) Send the print data to the printer.
NOTE: A NO PAPER status is shown by the control panel LEDs until you put a sheet of
paper in the manual feed tray.
(4) Open the manual feed tray. Slide the paper
guides to fit the envelope size.
NOTE: <Envelopes that have been creased after they have been printed>
At the back of the printer, open the back output tray and push down the blue tabs at the left
and right hand sides (as shown in the figure below). When you have finished printing your
envelopes, close the back output tray to reset the two blue tabs back to their original position.
Fig.2-17
Fig.2-18
Fig.2-20
2-18
Fig. 2-19