Brother HL 5030 - B/W Laser Printer Service Manual page 50

(5) Using both hands put the envelope in the manual feed tray until
the front edge of the envelope touches the paper feed roller.
Hold the envelope in this position until the printer automatically
feeds it in for a short distance, and then let go of the envelope.
NOTE;
•
Make sure the envelope is straight as you insert it sideways in the manual feed tray. If it
is not, the envelope may not be fed properly, resulting in skewed printout or a jam.
•
Do not put more than one envelope in the manual feed tray at any one time, or it may
cause a jam.
•
Put the envelope in the manual feed tray with the side to be printed face up.
•
If you put any Media (paper, transparency and so on) in the manual feed tray before the
printer is in the READY state, the media may be ejected without being printed on.
(6) After the printed envelope comes out of the printer, the printer will wait until you put in
the next envelope. Repeat Step 5 for each envelope you want to print.
(7) After you finish the print job, close the back output tray.
NOTE: Envelopes joints that are sealed by the manufacturer should be secure.
All sides should be properly folded without wrinkles or creases.
Printing on envelopes from the MP tray (For HL-5050 and HL-5070N)
The printer has a straight paper path from the MP tray to the back of the printer. Use this
paper feed and output method when you want to print envelopes.
The printer automatically turns on the MP Tray mode when you put paper in the MP tray.
When printing on envelopes, follow the steps below.
(1) Select the Paper Size, Media Type and paper Source etc. in the printer driver.
(2) Open the back output tray.
(3) Open the MP tray and lower it gently.
(4) Pull out the MP tray support flap.
HL-5030/5040/5050/5070N SERVICE MANUAL
Fig.2-22
Fig.2-23
2-19
Fig.2-21