Motorola MC9094-KUCHJERA6WR - MC9094-K - Win Mobile 6.1 Professional 624 MHz User Manual page 208

7 - 8 MC909X User Guide
Troubleshooting the Four Slot Ethernet Cradle (Continued)
Table 7-4
Symptom
Mobile computer has
successfully
connected through
the cradle, but no
data is being
transmitted over the
connection.
All Communication
Status LEDs are
flashing red.
Communication
Status LED does not
light up.
Cause
Data is being Temporarily disable the radio link to force data transmission
transferred over the through the cradle. Tap the wireless LAN icon from the systray.
S24 radio link.
Enter an in-valid value in the ESSID: text box and tap the OK
button. Power cycle the mobile computer. Verify that your radio
link has been disabled (the wireless LAN icon has a red box
with an "!" on it).
Once you have completed your data transmission, re-enable
your radio link.
The unit could not Connect the unit to an Ethernet network with a correctly
configure itself, or it functioning DHCP server.
has lost the lease on
its IP address.
Failed automatic Connect a properly configured DHCP server or DHCP relay
cradle configuration agent to the subnet, and power cycle the cradle. Check the
via local DHCP DHCP server log to verify that the cradle is receiving a
service. response to its DHCP request.
The Ethernet link Ensure the ethernet cable is connected to an active hub.
may be down.
Mobile computer has Remove, wait a minute, and then reinsert the mobile computer,
been inserted ensuring it fits snugly onto the connector at the bottom of the
incorrectly into the cradle.
cradle.
Cradle is not Ensure the power supply is securely connected and receiving
receiving power. power.
Solution