Pci Hot Plug Led Board; Removing The Pci Hot Plug Led Board - HP Integrity rx4610 User Manual

Chapter 8

PCI Hot Plug LED Board

The PCI Hot Plug LED Board resides just on the inside of the top rear of the
chassis. This board enables PCI hot plug boards to be plugged into and out of the
system without it being shut down.

Removing the PCI Hot Plug LED Board

To remove the PCI Hot Plug LED Board, complete the following procedure:
1. Observe all safety and ESD precautions for handling electronic
components.
2. Turn off all peripheral devices connected to the system.
3. Power down the server by pressing and holding the Power button on the
Front Control Panel. You may have to hold the Power button down for
several seconds. Removing the power cords ensures that the server is not
under standby power.
WARNING Make sure that the rack is anchored securely, so it will not tip
when the server chassis is extended.
4. Pull the chassis out of the rack as far as it will go.
5. Loosen the two thumbscrews in the back of the chassis that secure the rear
cover.
6. Lift the rear cover to expose the non-hot plug PCI adapter board cover.
7. Loosen the screw that secures the non-hot plug PCI adapter board cover.
8. Grasp the cover by its exposed, long side and lift the cover away from the
chassis. You can completely remove the cover if you want by unseating
the slot hinge. Access is now available to the PCI Hot Plug LED Board.
9. Disconnect the cable attached to the PCI Hot Plug LED Board.
10. Locate and remove the four small, black plastic retaining pins on the board.
The pins are evenly spaced across the length of the board. To unlock the
pin, grasp the head of the pin from the inside and pull it until it clicks.
11. Carefully pull the PCI Hot Plug LED Board away from the inside of the
chassis and place it on an antistatic surface.
92
Server Management Boards