Setup Dialog - HP Integrity rx4610 User Manual

Chapter 11

Setup Dialog

The BIOS setup (F2) menu has the following selections:
->Advanced->Chipset Configuration->Memory Related Items:
Table 11-3. Memory Test Setup Items
Name
System ECC
First Row Test Interval
Base Memory Test
Interval
Extended Memory Test
Interval
Defective DIMM Mapout
Clear Bad Memory Row
Info
The test interval entries determine how much of the target memory is tested. The
default in all cases is 4 cache line per 16 MB (fastest mode). In the alternate
mode, each cache line is tested.
The 'Defective DIMM Mapout' is used to turn off mapout completely. If this is
disabled, defective DIMMs will be detected, but not mapped out on the next
BOOT. This may lead to data corruption and loss and HP DOES NOT
RECOMMEND that this feature be disabled in the BIOS.
The 'Clear Bad Memory Row Info' is used to clear the history, and retest all
memory. This option is used when defective memory has been replaced, and the
user wishes to place it in service again. This option automatically goes back to
'disabled' after the next boot.
194
Selection
Enabled
Disabled
4 cache line per 16 MB
Every location
4 cache line per 16 MB
Every location
4 cache line per 16 MB
Every location
Enabled
Disabled
Disabled
Enabled
Troubleshooting
Comments
Default
Default
Default
Default
Default - Enables map out
Disables map out – NOT
RECOMMENDED
Default - Don't clear
history
Clear history