Yamaha Electone STAGEA ELB-01 Owner's Manual page 119

2
Select the parts for recording.
Each press of a part button switches the status: Play (green LED), Off (LED is
off ) and Rec (red LED). Press each part button to turn off the parts you don't
want to record, and make sure the green LED is lit for the parts you want to play
and the red lit for the part you want to record.
To record the performances on the Lower Keyboard and Pedalboard, turn off the
LED above the [UPPER] button, and make sure that the red LEDs above the
[LOWER] button and the [PEDAL] button are lit, as shown in the lower
illustration above.
3
Press the [PLAY/PAUSE] button. After "REC~~" appears at the top
right of the LCD display, begin playing.
4
Press the [Stop] button when you are finished with your
performance to stop recording.
Now you've recorded the first parts of your performance.
Setting up recording of the next part—Upper part in this case.
5
Press the [RECORD] button.
A message appears prompting confirmation of operation. To overwrite, press the
[C] button corresponding to [OK] in the display.
6
Select the parts for recording.
Set the parts you want to record next (in this case, the Upper part) to "Rec" (red
LED). Also set the part already recorded (in this case, the Lower and Pedal parts)
to "Play" (green LED), so that you can hear the previously recorded parts as you
record new ones.
Play (green LED):
Playback of parts that have been recorded.
Off (LED is off ):
Recording or playback is not active.
Record (red LED):
Recording of the part.
ELB-01 Owner's Manual 119
6