Yamaha Electone STAGEA ELB-01 Owner's Manual page 27

Setting the Volume in the display (fine)
Pressing the same Voice button on the panel again after selecting the Voice calls up the
Voice Condition display. The Volume is displayed in the top left of the Voice
Condition display Page 1. You can change the Volume by using the DATA
CONTROL dial when the arrow indicator ("¿" or "÷") next to the Volume value is
flashing. If the arrow indicator is not flashing, press one of the [A] – [D] buttons
corresponding to the item or parameter you want to change to make the indicator
flash, then use the DATA CONTROL dial to select the desired control setting.
The range of the Fine volume control is 0 – 24.
Voice Condition Display
VOL.¿24
TOUCH¿ 8 FEET÷PRESET
Pressing a Voice button once calls up the Voice Menu display for the selected
button. Pressing it a second time calls up the Voice Condition display. Successive
presses alternate between the two displays.
Voice Menu Display
<STRINGS/VIOLIN>
¿01:Strings 1
From the Voice Condition display, you can control Voice-related parameters such as
Pan, Effect, Volume, and so on. For more information on the Voice Condition
display, see page 41.
REV.÷20 ¨1⁄
Voice Condition Display
¨1 VOL.¿24
TOUCH¿ 8 FEET÷PRESET
Depending on the volume
value (set in the display),
two adjacent Volume button
lamps may be lit at the same
time, indicating an
intermediate position.
Selecting from the Voice
Condition display (page 41)
REV.÷20 ¨1⁄
ELB-01 Owner's Manual
NOTE
2
Reference Page
27