Yamaha Electone STAGEA ELB-01 Owner's Manual page 120

NOTE
When you record the
Keyboard Percussion, make
sure that the KEYBOARD
PERCUSSION [1] and/or [2]
button is set to on.
6
120 ELB-01 Owner's Manual
7
Press the [CUSTOM PLAY] button to start recording of the new
part or parts.
Playback of the previously recorded parts starts immediately. The [CUSTOM
PLAY] button is used here to record only the parts that have been selected for
recording, and plays back only those parts that have been selected for playback.
While you listen to the parts being played back, start playing the melody on the
Upper Keyboard.
When the end of the recorded performance is reached, playback is automatically
stopped. The length of a subsequently recorded part cannot exceed the length of
the previously recorded parts.
Separately recording for Lead Voice and/or Keyboard
Percussion parts:
The Lead voice and the Keyboard Percussion can be recorded/played back
separately although there are no buttons for these parts. Set these in the display
shown in step 2 on page 119.
Press the PAGE buttons to select Page 3.
<PART>
XG VOL.¿100 KBP÷OFF
Press the [B] button to make the "÷" indicator flash, then use the DATA
CONTROL dial to select the status for the Lead Voice.
Press the [D] button to make the "÷" indicator flash, then use the DATA
CONTROL dial to select the status for Keyboard Percussion.
You cannot set both Upper and Lead to "Rec" at the same time; neither can the
Lower and Keyboard Percussion parts be recorded at the same time.
LEAD÷PLAY‹