HP D5970A - NetServer - LCII Configuration Manual page 101

Chapter 9
6. Enable HP NetRAID on SCSI A using the Setup (F2) utility. See "Step D.
Enable Integrated HP NetRAID Controller" in this guide for complete
instructions.
Integrated HP NetRAID should be set to Enable.
Included SCSI_A Channel should be set to Yes.
Included SCSI_B Channel should be set to Yes.
7. Boot the HP NetServer Navigator CD-ROM. You will see the following
message indicating that the drive roaming feature has moved your
existing physical drives from Channel 0 to Channel 1:
Drive roaming done.
8. When the NetServer Navigator Main Menu appears, exit and turn off the
power to the HP NetServer.
9. Insert the drives that you removed in Step 5. These drives are connected to
SCSI A which has just been enabled for HP NetRAID.
10. Boot the HP NetServer Navigator CD-ROM again. You will see the
following message:
New drives found. Configuration updated.
11. Launch HP NetRAID Assistant, following the instructions in "Step E" in
Chapter 5.
12. From the HP NetRAID Assistant main window, verify that your existing
hard disk drive information is correct. The drives with your existing data
have now moved to Channel 1 and their status should be "Online." The
new drives are now on Channel 0 and their status should be "Ready."
13. Select the Configuration menu, and then choose Wizard.
CAUTION
Do not clear your configuration! You don't need to change
the configuration of your existing HP NetRAID channel.
14. Choose either Custom or Automatic mode and define arrays, hot spares,
and logical drives on your second channel. Automatic mode will not affect
your existing configuration. For complete instructions on configuring
arrays and logical drives, see "Step F" in Chapter 5 of this guide.
15. Save your configuration and initialize your new logical drives as described
in "Step G" in Chapter 5 of this guide. Exit HP NetRAID Assistant.
Configuring a Second Integrated HP NetRAID Channel
95