HP D5970A - NetServer - LCII Configuration Manual page 140

Index
ready state of physical drive, 43
Ready status of SCSI disk, 127
rebuild
operation, 127
status of SCSI disk, 128
rebuild rate, 32, 127
planning, 32
setting or verifying, 44
rebuilding state of physical drive, 44
Reclaim button
for hot spare, 49
Redundancy check box, 46
remote management, 77
rescan, 45
reset (clear) configuration, 44
restore data, 128
roaming, disk, 3
S
save binary file, 55
scatter/gather, 3
SCSI A, 25
SCSI B, 25
SCSI channels
adding a second channel, 91
HP NetRAID, 127
physical drives on, 43
planning, 25
SCSI disk status, 127
SCSI ID
in HP NetRAID, 128
of physical drive, 43
SCSI transfer rate, 27, 62
Setup utility, 39
Span Arrays check box, 50
spare (hot spare) state of physical drive,
43
starting HP NetRAID Express Tools,
62
states of physical drives, 43
Step A. Plan Your Hardware, 23
134
Step B. Plan Arrays and Logical
Drives, 27
Step C. Verify Hardware Setup, 39
Step D. Enable Integrated HP NetRAID
Controller, 39
Step E. Boot HP NetServer Navigator
to Launch HP NetRAID Assistant,
41
Step F. Configure Arrays and Logical
Drives, 41
Step G. Save Configuration and
Initialize, 55
Step H. Decide Which HP NetRAID
Drivers You Need, 57
Step I. Use the HP NetServer Navigator
CD-ROM to Prepare Disks, 58
Step J. Install NOS and HP NetRAID
Drivers, 60
Step K. Install NOS-specific
Configuration Utility, 61
Step L. Run Configuration Utilities, 62
Step M. Prepare for Online Capacity
Expansion, 65
stripe size (depth)
HP NetRAID, 128
planning, 35
setting, 51
stripe width, 129
striping, 128
T
tagged command queuing, 3
toolbar options, 43
U
Undo button, 52
undoing
hot spares, 49
logical drives, 52, 54
physical drives, 54
UPS and I/O cache policy, 36
utilities