10 Configuring the HP NetServer
Introduction
This chapter describes configuring the HP NetServer:
l
Configure mass storage as either:
NetRAID (default)
LVD SCSI
l
Updating the BIOS
l
Selecting a language (for example, French)
l
Installing the Network Operating System (NOS)
NOTE
HP NetServer Navigator CD-ROM
Use the HP NetServer Navigator CD-ROM (Navigator) to perform configuration
tasks and view system information. For example, you can print a copy of this
installation guide for your network operating system.
l
Boot the NetServer with the Navigator CD-ROM to perform the
configuration tasks.
l
Run Navigator on any PC or workstation before powering up the HP
NetServer to make diskettes to use to configure the HP NetServer later.
Using a Separate Workstation to View Navigator Information
You can run Navigator from a PC or workstation. You can then view many of the
administration functions and create diskettes containing necessary tools and
drivers. From your desktop or laptop:
1. Insert the Navigator CD-ROM in the CD drive.
The HP NetServer ships with NetRAID as the default. If you
plan to configure mass storage as LVD SCSI, change the
default using the Setup Utility prior to installing the NOS.
107