Removing The Lh 3000 Covers - HP D7171A - NetServer - LPr Installation Manual

Chapter 3

Removing the LH 3000 Covers

1. Unlock the bezel, using the supplied key.
The bezel connects to the chassis with two snap-in connectors inside its top
left and right corners and two tabs that fit into two slots on the bottom of
the chassis.
2. Remove the bezel.
a. Pull bezel toward you until it unsnaps.
b. Lift the bezel forward and upward from the chassis face.
Pull bezel toward you, then up
and away from the front panel,
releasing the tabs from the slots
at the bottom of the front panel.
Figure 3-8. Removing the HP NetServer LH 3000 Bezel
CAUTION The NetServer covers are heavy. Support them as you remove
them, and allow room to move them away from the NetServer
and for storage when removed.
36
Opening and Closing the HP NetServer
2.
3.
1.