HP D7171A - NetServer - LPr Installation Manual page 74

Chapter 6
11. Align the board with its slot along its full length, and push it into the slot
with even pressure along the top edge of the board until it is fully seated in
its connector.
NOTE
To prevent EMI problems, ensure each unused PCI slot has a
PCI slot cover. If a PCI board is removed and not re-installed,
you must install a PCI slot cover.
12. Close the PCI hold-down latch, by reversing the procedure in step 9.
NOTE
Be sure the PCI hold-down latch closes fully (clicks) so that
the slot will power on when the HP NetServer boots.
13. If the installed accessory board requires an external connection or a
connection to the I/O board, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
14. Replace the front board hold-down.
66
Figure 6-4. Install Non-Hot-Plug Board
Installing Additional PCI Boards