HP D7171A - NetServer - LPr Installation Manual page 128

Chapter 10
I 0 Settings – Use this menu to set the maximum number of I
2
(4), the message timeout multiplier (1 to 1000), the pause interval
during POST, or start the IRTOS (I
manually.
Embedded LAN and SCSI Settings – Use this menu to:
Change between HP NetRAID (default) and LVD SCSI modes
set the Embedded NIC to enable, disable, or enable as a boot device
(Boot ROM Enabled).
If the embedded NIC is enabled as a boot device, boot ROMs for
enabled SCSI devices cannot be loaded.
Enable and disable the Wake-On-LAN feature.
Keyboard and Mouse Settings – Use this menu to set the parameters
of the keyboard, including NumLock, and set the PS/2 mouse to Auto
(detect)/Enabled/Disabled. Disabling the mouse frees up IRQ 12, but
prevents any installed PS/2 mouse from functioning.
Flexible Disk and IDE Settings – Use this menu to change the flexible
disk type or add an IDE hard drive to HP NetServer's configuration.
This would include selecting the hard drive's characteristics manually
or automatically, and selecting which drive would be the Primary
Master or Slave, the CD-ROM or the IDE hard drive.
Processor/Memory Settings – Use this menu to select if the processor
module's serial number (if supported) will be read by firmware, enables
memory caching, and adds an extended memory gap in system address
space.
Security – Provides two submenus to choose from.
Power-On Password – Sets the administrator and user passwords, sets
system to require a password after booting.
The Administrator password must be set before setting the User
password. Once the administrator password is set, the administrator can
access and change all fields in the screens.
If the User password is set, the user may only change the system time,
date, and user password. The user may view all fields, but cannot alter
any of the settings.
Hardware Security – Sets the system parameters for operating in
Secure Mode.
120
Configuring the HP NetServer
2
0 Real Time Operating System)
2
0 drives