Password Problems - HP D7171A - NetServer - LPr Installation Manual

Chapter 12
4. Plug in the power cord and turn on power to the HP NetServer. The
following message appears:
The configuration has been cleared. Set the
Clear Config switch to the OFF position
before rebooting.
5. Turn off power to the HP NetServer and unplug the power cord.
6. Return switch 5 on the system board to the OFF position.
7. Replace the top cover and the front bezel, then plug in the power cord.
8. Turn on power to the HP NetServer. The error message may be displayed:
0012-34 :
9. Press the [F2] function key and answer
then exit the Setup utility.

Password Problems

If you have forgotten the password, your HP NetServer will function normally,
but you will not be able to change the system configuration settings in the Setup
utility. To reset the password:
1. For rack-mount and pedestal models, follow the instructions in Chapter 3,
"Opening and Closing the HP NetServer," to gain access to the server.
2. Turn off power to the HP NetServer and unplug the power cord.
3. Refer to Figure 12-1 and move switch 6 on the system board (labeled "
Clear Password") to the ON position.
4. Plug in the power cord. Turn on power to the HP NetServer, and allow it to
complete its startup routing. The old password will be erased.
5. Turn off power to the HP NetServer. Unplug the power cord.
6. Return switch 6 to the OFF position.
7. Replace Cover 2 and the bezel.
8. Plug in the power cord. Turn on power to the HP NetServer and allow it to
complete its startup routine.
9. If you wish to set the password again, during the power-on system
hardware test press the [F2] function key to start the Setup utility.
10. Set the new password in the Security menu.
11. Press the [F10] function key and answer
including the new password.
142
Incorrect System Configuration
Yes to save the configuration,
Yes to save the configuration,
Troubleshooting