Creating Driver Diskettes - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
Installing the Drivers when NetWare 5.1 is
Already Installed
Loading the NetWare Drivers at Server Bootup
Unix Environment
Installing the UNIX Drivers on a Boot Container
Installing the UNIX Drivers on a Data
Container
Additional Operating Systems
Note:
You must install the Windows NT or NetWare drivers
for your controller before you install the Controller
Management Software. If you wish to use a container as the
boot container, first create the boot container as described in
Appendix B, Using the BIOS Container Configuration Utility.
Then, install the drivers as you install the operating system.
The operating system will then reside on the boot container
and has the redundancy and performance features of that
container.
Note:
If you are upgrading your controller's software and
firmware from an earlier version, see Chapter 3, Performing
an Upgrade Installation before installing the device drivers.

Creating Driver Diskettes

The HP NetRAID-4M drivers are located on the HP NetServer Navigator
CD, version L.19.10 or greater (the HP NetRAID-4M always comes with
the latest HP NetServer Navigator CD version). To create your driver
diskettes, do the following:
1
Insert the HP NetServer Navigator CD into any Windows system.
2
Select the Diskette Library.
3
Select the appropriate driver for your NOS. NOS Drivers <nosname>
<NetServer Name>.
4
Follow the on-screen instructions.
4-2
page 4-15
page 4-17
page 4-18
page 4-18
page 4-21
page 4-27