Windows Environment; Installing The Drivers During A Fresh Install Of Windows Nt - HP D7171A - NetServer - LPr Installation Manual

Windows Environment

To install the drivers while installing Windows NT see Installing the
Drivers During a Fresh Install of Windows NT below. To update or
install the drivers when Windows NT is already installed see
Installing the Drivers When Windows NT is Already Installed on
page 4-5.
If you are installing drivers while upgrading from Windows NT to
Windows 2000, see Installing the Drivers When Upgrading to Windows
2000 on page 4-6. If you are installing drivers during a fresh
installation of Windows 2000, see Installing the Drivers During a Fresh
Install of Windows 2000 on page 4-8.

Installing the Drivers During a Fresh Install of Windows NT

Follow these instructions to install the Windows NT drivers while
you are installing Windows NT. Windows NT will be installed on a
boot container if you created a boot container with the Container
Configuration Utility. (For information on creating a boot container,
see Appendix B, Using the BIOS Container Configuration Utility.)
Note:
Microsoft has acknowledged that Windows NT 4.0 has
a known 1 GByte maximum partition creation limitation
when NT 4.0 is installed on SCSI controllers that contain
two or more drives. We recommend, therefore, that prior to
installing NT 4.0 on the controller, you should create only
one container using the BIOS Container Configuration
Utility (refer to the section Creating a Container on page B-2
for information about container creation). Following the
installation, you can then use FAST to create multiple
containers.
For more information about the Windows NT partition size
limitation, see the Microsoft Website, www.microsoft.com.
Installing Windows NT 4.0 from CD
1
Start your system with the Windows NT boot CD in the
CD-ROM drive and proceed with the Windows NT
installation.
Installing the Device Drivers
4-3