Installing The Driver When Netware 4.20 Is Already Installed - HP D7171A - NetServer - LPr Installation Manual

Hewlett-Packard NetRAID-4M Controller Installation Guide
21
Install the Novell NetWare Support Pack 7 or higher for
Version 4.20.
Caution:
Novell recommends installing the Support
!
Pack on your server from a client. If installing the
Support Pack from a CD, mount the CD as a NetWare
volume and then install the software.

Installing the Driver When NetWare 4.20 is Already Installed

To update or install the netr4m.ham driver when NetWare 4.20 is
already installed, follow the instructions in this section. Before you
begin, make a backup copy of the old driver (if it exists) before
installing the new driver.
1
At the NetWare console, type load install.
2
Select Driver Options and press Enter.
3
Select Configure disk and storage device drivers and press
Enter.
4
Select Select an additional driver and press Enter.
5
Check that the proper driver for any embedded SCSI
controllers is installed.
Note:
If the embedded driver has not been installed,
install it before installing the HP NetRAID-4M
drivers. Refer to your Hewlett-Packard server
documentation for further information.
6
Press Insert to install an unlisted driver.
7
Insert the HP NetRAID-4M driver diskette for NetWare V4.2
(NOS Drive - NetWare 4.20 <NetServer Name>) into the
diskette drive.
8
An explanatory screen appears. Press Enter to have the system
scan the diskette for the HP NetRAID-4M driver.
9
Select netr4m.HAM Hewlett-Packard Array Controller and
press Enter. This will bring you to the HP NetRAID-4M
Parameters screen.
4-12