Overview Of The Cluster Software Installation Procedure - HP D7171A - NetServer - LPr Installation Manual

2
When prompted during the boot sequence, press <CTRL><A>
to enter the CCU. If your system has multiple controllers, be
sure to select the correct controller number.
3
The CCU displays an initial menu, from which you select the
SCSISelect Utility.
4
The SCSISelect Utility displays a menu, from which you select
SCSI Configuration.
5
The SCSISelect Utility displays another menu from which you
can select a SCSI channel (either #0, #1, #2, or #3). Select the
SCSI channel for the shared SCSI channel being used in the
cluster.
6
The SCSISelect Utility displays a Configuration menu for the
channel you selected in the previous step. Under the top-most
section of the menu, SCSI Channel Interface Definitions, do
the following:
a
To enable clustering, move the arrow key to Clustering and
change the setting from Disabled to Enabled.
b
Ensure that the SCSI channel being used for the shared
cluster channel has a unique ID that is not in conflict with
the corresponding channel on the other node in the cluster
or with any devices on the shared channel.
To do this, check the SCSI Channel ID listed next to the
heading Controller SCSI Channel ID, and if necessary
change the ID to make it unique.
7
Follow the on-screen instructions to exit the SCSISelect Utility
and the CCU. When you exit the CCU, the system reboot
continues.
Overview of the Cluster Software Installation
Procedure
The HP NetRAID-4M Cluster software contains a Hewlett-Packard
extension to the Microsoft Cluster Administrator utility (provided
with the Microsoft Cluster Service software). The Hewlett-Packard
extension consists of a resource DLL and an administrative DLL
which enable you to use Cluster Administrator, in addition to FAST
and the CLI, to manage shared storage.
Installing Clusters
7-3