Site Preparation Checklist - HP D7171A - NetServer - LPr Manual

Chapter 2

Site Preparation Checklist

Table 2-1. Site Preparation Checklist
HP NetServer Customer Responsibilities
Logical and physical network design provided.
Server configuration parameters determined.
Disk partition and directory structure determined.
Required incoming power and data cabling in place.
Working LAN, one working client, one working printer available (if integrating into an
existing network).
Software license requirements met.
Networking peripherals connected.
Security
The HP NetServer LH 4r must be installed only in locations where access is restricted to
technically qualified personnel.
Use the locks on rack doors to secure the HP NetServer LH 4r control panel and rear ports.
Floor
Ensure the floor where the NetServer rack is to be installed is level.
Assess floor strength and ensure it is sufficient to support the type of rack you have
ordered. (See the rack documentation included with your rack.)
Ensure sufficient area to accommodate your rack, including up to 24 inches (60 cm) rear
door clearance.
Power
Correct size, type, and rating of receptacles, circuits, and circuit breakers; see the section
titled "Site Preparation: Circuit Breakers."
Locate close enough to power sources so that power cords will reach.
If raised floor, need floor tile(s) with a cutout for cables, all posts electrically grounded.
Facility for grounding each rack to earth connection, ensure earth ground continuity for
circuits to be used for rack mounted equipment.
Connecting and Routing Cables to the HP NetServer LH 4r
13