Adjusting The Movable Knife Installation Position - Brother RH-9820 Instruction Manual

9. STANDARD ADJUSTMENTS

9-26-3. Adjusting the movable knife installation position

(Viewed from underneath)
1. Remove work clamp plate U. (Refer to "9-26-1. Replacing the movable knife and fixed knife".)
2. Loosen the screw (1).
3. Turn the movable knife driving plate (4) so that the tip [A] of movable knife R (3) and the corner [C] of the needle plate (2) are
aligned.
4. Turn thread trimmer lever arm B (7) until the thread trimmer link lever J assembly (5) touches against the screw (6), and then
tighten the screw (1).
5. Once adjustment is complete, install work clamp plate U.
NOTE:
Check that the movable knife driving plate (4) and thread trimmer lever arm B (7) turn smoothly with no play.
105
(Viewed from directly above)
(Viewed from the side at position B)
RH-9820
0528B