3-6. Installing the belt cover and feed bar cover U
0351B
3-7. Installing the oiler
0350B
0619B
The oiler should be installed while the machine head is tilted
0353B
back.
(Refer to "3-5. Tilting back and returning the machine head".)
(1) Dust oiler support
(2) Screws [2 pcs.]
(3) Oiler
(4) Oiler spring pin
•
Use a hammer or similar to tap the pin (4) so that its head
is flush with the base of the oil pan (5).
NOTE:
When tapping in the pin (4), check that the knot in the
wick (6) is below the top of the pin (4) as shown in the
illustration at left. If the knot is above the pin (4), it may
become hit by the hammer and this may cause the
wick (6) to break.
•
Once installation is complete, return the machine head to
its original position.
0354B
RH-9820
3. INSTALLATION
(1) Belt cover
(2) Screws [4 pcs.]
•
Before installing the belt cover, pass
the cords through the belt cover
notch (3).
NOTE:
•
Be careful not to clamp the cords when
installing the belt cover. If care is not
taken, the belt cover and cords may
become damaged.
•
If using the embedded installation
method, check that the belt cover (1)
does not touch the table when the
machine head is tilted back.
(4) Feed bar cover U
(5) Screws [2 pcs.]
NOTE:
If the screws (5) are tightened too
much, the feed bar cover U (4) may
become cracked.
12