Bbc Cable Removal (Toro Vacu Power/Lawn-Boy Medallion) - Toro 20330 - Low Wheel Walk Power Mower Service Manual

11. Complete BBC service by checking BBC and self-
propel controls, making sure that all are functioning
normally. Adjust as necessary.
BBC Cable Removal (Toro Vacu Power/
Lawn-Boy Medallion)
1. Remove the two fl anged head self-tapping screws
securing the screen panel to the housing and
remove the screen panel as shown in Figure 178.
A A
A. Screws
2. On early models, the end of the BBC cable sheath
has two protruding ears that catch the underside of
the cable bracket. Remove the cable by squeezing
the ears together, then pulling the cable out
vertically. Later models use a clip that must be
pushed to the side to remove.
WPM Drive Systems Manual
B B
Fig 178 3428-0079
B. Screen Panel
BBC / BOS / BCS
3. Bend the throttle control locking tab back slightly and
tap the throttle control from the control panel with a
rubber mallet. Place a piece of duct tape over the
heads of the handle and the BBC control box. This
will prevent the control box components from falling
out of the handle during disassembly.
4. Remove the three fl anged head screws securing the
control box halves.
5. Remove the two nylon locknuts securing the control
box to the handle and carefully remove the right
control housing half.
6. Slip the end of the BBC cable from the cable lever
and remove the cable (Fig. 179).
A. BBC cable lever
Fig 179
B. BBC cable
fi g 36
6-19