Transmission Disassembly; Transmission Assembly - Toro 20330 - Low Wheel Walk Power Mower Service Manual

SINGLE SPEED BEVEL GEAR TRANSMISSION
6. You can now release the clamps and separate the
HOC plate, spring arm, and pivot arm (Fig. 081).

Transmission Disassembly

1. Remove the 4 screws holding the cover on the
transmission. The axle, bearings, and bevel gear
can be lifted out (Fig. 082).
3-16
Fig 081 MVC-750
Fig 082 MVC-462
2. Since the pulley was previously removed, the input
shaft will now slip out of the transmission case.
3. If the input bearing is to be removed, press it out
now.
4. Slide the bearings and thrust washer off the axle.
Drive the roll pin out and the bevel gear can be
removed (Fig. 083).

Transmission Assembly

Assemble in reverse order.
Fig 083 MVC-470
WPM Drive Systems Manual