Bellcrank System Assembly (Toro Vacu Power/Lawn-Boy Medallion) - Toro 20330 - Low Wheel Walk Power Mower Service Manual

4. Remove the bushing from inside the bellcrank.
5. Using the control link to hold the control pin, remove
the fl anged head screw from the control pin (Fig.
166).
CAUTION! Always wear safety goggles and
gloves when disassembling items under spring
tension or compression.
6. Remove the control link from the control pin.
7. Inspect all parts for wear and damage and replace
as necessary.
Bellcrank System Assembly (Toro Vacu
Power/Lawn-Boy Medallion)
1. Insert the control pin into the recessed area on the
bellcrank.
WPM Drive Systems Manual
Fig 166 3428-0093
BBC / BOS / BCS
2. Place the spring onto the control pin. Place the
spring retainer onto the spring and insert the screw
into the control pin. Using the control link to prevent
rotation of the control pin, tighten the fl anged head
screw until the retainer bottoms out on the control
pin (Fig. 166).
3. Note the orientation of the control link in Figure
167. Make sure that it is installed correctly into the
bellcrank.
A A
B B
A. Brake plate lever
B. Control link
C. Shoulder bolt
4. Slide a fl at washer and a bushing onto the shoulder
bolt and slide into the front side of the bellcrank
as shown in Figure 000. (3428-0088) Complete
reassembly of the bell crank system by sliding
another fl at washer onto the carriage bolt.
Note: Lubrication of the bushing is not
recommended.
E E
D D
C C
Fig 167 3428-0088
D. Bellcrank
E. Cable bracket support
6-13