SINGLE SPEED BEVEL GEAR TRANSMISSION
Rear Axle Disassembly
1. Remove the klip rings and thrust washers that
secure the pinions to the axle (Fig. 077).
2. When removing the pinions, note that there is a
spring-loaded key under them.
3. Remove the other thrust washer and retaining ring
holding the pivot assembly to the axle (Fig. 078).
WPM Drive Systems Manual
Fig 077
MVC-746
Fig 078
MVC-850
4. The pivot assembly will slide off the axle. This
includes the bearing, bearing retainer, HOC plate,
spring arm, and pivot arm (Fig. 079).
5. Clamp the pivot assembly with 2 pairs of locking
pliers or other clamps and remove the snap ring
(Fig. 080).
Fig 079
MVC-747
Fig 080
MVC-748
3-15