Disassembly - Bosch NWD-455V03-20P Operating Instructions Manual

FlexiDome IP
2

Disassembly

The camera/housing unit consists of the following parts:
Fig. 2.1 Exploded view
CAUTION!
Installation should only be performed by qualified service
!
personnel in accordance with the National Electrical Code or
applicable local codes.
CAUTION!
!
The camera module is a sensitive device and must be handled
carefully. Do not drop when disassembling the unit.
To disassemble the unit proceed as follows:
1. Using the special screwdriver bit, loosen the three tamper-
resistant screws in the trim ring (the screws remain in
place).
2. Remove the trim ring with dome by pulling it off of the
base.
3. Remove the inner liner by pulling it off of the base.
4. Loosen the three Phillips captive screws until the mount-
ing plate separates from the body
Bosch Security Systems
Mounting plate
Camera module and mounting base
Inner liner
Trim ring and dome
Operating Instructions
Disassembly | en 21
V 1.0 | 2006.12